Posted May 08, 2015 by Gabriel Posternak

How To Install a Light Dimmer And Save Money On Energy Bills

If you really want to create an energy efficient home and reduce your energy bills, the best way to save energy is to look at the lighting system throughout your home. Of course, you don't have to wait until your next home improvement project to do so, but if you happen to be planning one, keep in mind that that's the perfect moment. Seize the great opportunity to save money, save energy and make a change for the better!

Among the lots of things you can do to improve your current lighting system, there's one in particular that isn't expensive - but can provide amazing benefits in the long run: light dimmers. Installing them, for one thing, will surely make you save money. The less electricity you consume, the less you will have to pay for, as well. Also, you get to save energy. Whether you are fully involved in the green energy movement, or just starting out, everyone is aware of how vital it is now to save energy. Moreover, you get to control the mood and ambience of a room with a light dimmer switch.

shutterstock_238692676

Already interested in dimmers? Then check our how easy is to install them in your home!

  1. Seek what type of dimmer you will be installing - there are LOTS of types of dimmers, so be extra sure to pick the one that works best for you. See if you have more than one switch that operates the fixture you are wanting to dim, since that will influence what you choose.
  2. Shut off the electricity to the switch either at the circuit breaker or fuse box. Make certain it is offbefore doing anything!
  3. Put the switch into the off position.
  4. Remove the wall plate and any hardware.
  5. Make certain that the wires are not live wires.
  6. Check again to see if electricity is off – use a voltage tester, switch the correct breaker to the off position or remove the fuse.
  7. Disconnect the older wires from the existing fixture.
  8. If necessary, strip the wire insulation by 3/8 to 5/8 of an inch with a wire stripper.
  9. Connect the wires. Connect the lead wires to house wires using wire connectors and wrap those with electrical tape. Connect green ground wires to copper ground wires in the box using a supplied connector and twist clockwise to tighten.
  10. Place wires back into the electrical box and attach the dimmer to the electrical box with the mounting screws.
  11. Put back the wall plate with screws.

Given how easy it is to install it, you should really try it to do it yourself. However, if you have any questions or uncertainties, check with an electrician in your community. At all times, it is better to be safe rather than be sorry.

At the end of your project you will have installed a light dimmer switch and can feel good knowing that not only are you saving electricity, you are saving energy as well. Now, you can play with the different settings and take control of the mood and tone of each individual room to have it be to your liking.

SHARE THIS
RELATED POSTS
No related post found